Place the source spool on the side that says “source” (right side of image). You may need to change the fittings for it to fit securely.Feed the filament through the bowden tube to the empty spool. You should secure the end of the empty spool with some tape or try to hook it into centre before starting.Using the hex bit on the power drill slowly start to wind the filament. Check occasionally that the filament is being distributed evenly. Make sure to slow down near the end.
Link to video of the filament winder/respooler in action.
Tips After spooling the change in tension in the filament may cause breakages. To resolve this you can either respool it again or put it in the filament drier for a few hours to reset the tension.
$ per
Total usage0
Base cost$0.00
Minimum adjustment$0.00
Grand total$0.00
Add as many rows as you need; values will be summed.
